Bore Tech’s Chameleon Gel™ is a patented, high-tech, colour-indicating cleaner and polish that effectively removes severe Carbon, Copper, Lead and Moly fouling. This patented chemical and mechanical cleaning technology is odour free, biodegradable and 100% safe for all barrel types. The easy to use gel formulation requires no mixing and cleans up quickly for a shiny barrel every time. Available in a 2oz tube.

CHAMELEON GEL IS RECOMMENDED FOR

CHAMELEON GEL IS 100%

Traditional abrasive bore pastes solely rely on aluminium oxide grit and mechanical abrasion to remove fouling. Complicating matters, this decades-old technology turns black whether the barrel is copper fouled, carbon fouled or 100% clean. Shooters have no indication of their bore condition and in turn overuse the traditional bore pastes damaging their barrel. Not with Chameleon Gel!

Chameleon Gel safely cleans fouling in half the time of traditional abrasive bore pastes by utilizing a micron-sized, silica-based polish that creates an activation site for the patented chemical technology to quickly and effectively clean. It also changes colours to show what type of fouling is in the bore and when the bore is clean.

If you want to quickly, effectively and safely clean and polish your barrels, Bore Tech’s Chameleon Gel is the cutting edge cleaner/polish you have been looking for.

Are your firearms clean? Bore Tech Chameleon Gel will sure let you know!

Bore Tech Chameleon Gel™ Use Instructions

UNLOAD FIREARM

1. Wet 3 to 4 patches with C4 Carbon Remover or Cu+2 Copper Remover or Eliminator Bore Cleaner and individually push through the bore to remove loose fouling.
2. Next, using the correct calibre Bore Tech Proof-Positive jag and undersized Bore Tech X Count patches or an undersized Bore Tech Proof-Positive Nylon brush with a patch wrapped around it, evenly coat the patch with Chameleon Gel.
3. Short stroke the bore with the coated patches back and forth in 2-inch increments focusing on problematic areas
4. Observe colour (s) of the patch to indicate fouling type in the barrel:
   1. Blue/Green = Copper Fouling
   2. Black = Carbon Fouling
   3. Gray = Lead/Moly
   4. White = Clean Bore
5. Let Chameleon Gel remain in barrel for 3 – 5 minutes.
6. Repeat above steps as necessary. When the Chameleon Gel remains white in colour, bore is clean.
7. To Remove Chameleon Gel, individually push 2 to 3 wet patches of C4 Carbon Remover, Cu+2 Copper Remover or Eliminator Bore Cleaner through the bore.
8. Finally, push dry patches through the bore until they come out clean.
9. For storage or in adverse conditions apply Bore Tech Friction Guard XP Gun Oil.
10. Before using the firearm, always run a dry patch through the bore. This will remove any residue and ensure against obstructions.